Rouse-Tech

Monster Motor Products

As an Authorized AeroTech hardware manufacturer, our product line includes every piece of hardware needed for every Aero-Tech RMS (tm) motor. We start with our 18 millimeter hardware set and finish off with the 98 millimeter hardware. Our rocket motor hardware, in the 29 millimeter sizes and above, features hard anodizing on the rear closures and on forward closures on the 29,38 and 54 millimeter sizes.

Motor Reload Chart Compatibility
For your convenience, Rouse-Tech has created a chart listing all AeroTech RMS Reload Kits and their corresponding Monster Motor Hardware. Click here to view the chart.

Thread Sizes for Tapped Forward Closures
38mm forward closure	5/16" X 18 TPI
54mm forward closure	5/16" X 18 TPI
75mm and 98mm closure	3/8" X 16 TPI

Monster Motor Products
The following diameters of motor hardware are currently available from authorized Rouse-Tech dealers.

29mm Hardware
38mm Hardware
54mm Hardware
75mm Hardware
98mm Hardware

Product Availability:
Monster Motor Products are available from a variety of dealers. Click here to see a list of authorized Monster Motor dealers.

29mm Set

Shown from left to right are: 29/360 case, 29/240 case, 29/180 case, 29/120 case, 29/100 case and 29/60 case. Also shown are the forward open closure, forward seal disk, rear closure and forward plugged closure.The forward seal disk is used on all re-loads in the 29/360 and 29/240 cases.

38mm Set

From left to right- 38/240 case, 38/360 case, 38/480 case, 38/600 case, 38/720 case and 38/1080 case. Also shown is the forward open closure, rear closure, forward seal disk and forward plugged closure. Seal disk is used on all re-loads for 38/480, 38/600, 38/720 and 38/1080 cases.

54mm Set

Shown here from right to left is the 54/852 case, 54/1280 case, 54/1706 case
and 54/2560 case. Also shown are the following: 54mm tapped forward closure, plugged forward closure, plugged extended forward closure, open forward closure, extended open forward closure, and aft closure.

75mm Set

This is the Monster Motor 75mm hardware. Shown from right to left- 75/2560 case, 75/3840 case, 75/5120 case, 75/6400 case and 75/7680 case. Also shown are the tapped forward closure and aft closure.

98mm Set

Shown here is the 98mm hardware. Shown from right to left is the- 98/2560 case, 98/5120 case, 98/7680 case, 98/10240 case and 98/15360 case. Also shown is the rear closure, forward closure and forward closure with recovery shackle.

Monster Motor Closures

Close up photo of Monster Motor Closures in various sizes.

Click here to download the view an AeroTech hardware reload compatibility chart.